Search
VSMT Tackle Kit- Go Direct Structures & Materials Tester (GDX-VSMT ...
- The displacement should read 0.159 cm. Rotate the wheel back to its original position. Verify that it reads 0.00 cm. RELATED ARTICLES. Is the tackle kit for ...
- https://www.vernier.com/til/4505
- Vernier Structures & Materials Tester (VSMT) Troubleshooting and ...
- Replacement Parts. VSMT Tackle Kit (VSMT-TK). Published: August 12, 2019. Updated: July 23, 2025. ©2025 All rights reserved; Privacy Policy | Cookie Policy ...
- https://www.vernier.com/til/3344
- Can I use the Structures & Materials Tester to test plastic films ...
- Nov 1, 2024 ... ... (VSMT)) has the range and ... The bottom of the fixture attaches to the U-bolt that comes in the Structures & Materials Tester tackle kit.
- https://www.vernier.com/til/22338
- Truss Tester Accessory for Structures & Materials Tester Troubleshooting and FAQs
- The VSMT Truss Tester Accessory makes it possible to test single-width trusses on the Go Direct Structures & Materials Tester and the Vernier Structures &...
- https://www.vernier.com/til/3595/
- Is the tackle kit for Vernier Structures & Materials Tester (VSMT-TK) able to handle 1000 N of force?
- Some of the tackle kit components included with the Structures & Materials Tester (Go Direct or LabQuest) can bend when excess force is applied. This...
- https://www.vernier.com/til/3457/
- How do I tighten the force sensor in my Structures and Materials Tester (VSMT)?
- The force sensor portion of the may be loose in some units shipped in April 2015. Tighten the VSMT force sensor (also known as the...
- https://www.vernier.com/til/3497/
- How do I remove the force sensor from the Vernier Structures and Materials Tester (VSMT)?
- If the force sensor in your needs to be repaired or replaced, it can be removed from the device with a few simple steps. Removing...
- https://www.vernier.com/til/3464/
- Why is my VSMT force sensor stuck at a high reading (>1000 N)?
- There are at least two possible causes for the force sensor to read a high constant value. It has been stressed beyond its capacity and...
- https://www.vernier.com/til/3463/
- Can I use the Structures Tester for the Science Olympiad Boomilever event?
- The short answer is yes. A little construction is required to create a platform to connect the Test Wall to the Vernier Structures and Materials...
- https://www.vernier.com/til/4296/
- Will the VSMT work with SensorDAQ and LabVIEW?
- Yes, the force sensor on the VSMT will auto-ID with SensorDAQ and LabVIEW. The displacement sensor will work with some creativity: 1. In LabVIEW, choose...
- https://www.vernier.com/til/3418/
SAVE/SHARE YOUR CART