Control Analog Out, Digital Out and Pulse Out
Experiment #8 from Hands-On Introduction to NI LabVIEW™ with Vernier
- Subject
- Engineering
Introduction
In this exercise, you will create a program to control the SensorDAQ’s analog out terminal (pin 9 of the screw terminal connector).1 In addition, a Voltage Probe will be used to read the voltage of the analog out terminal. The Analog Express VI is a simple way to program data collection from a Vernier sensor. The DAQ Assistant Express VI is a simple way to control the SensorDAQ’s screw terminal channels. Steps will be taken to modify the VI to control the digital-out line and the counter line.
Objectives
In this exercise, you will
- Create a LabVIEW VI to control and measure the screw terminal analog-out line.
- Modify the VI to control and measure one of the four digital-out lines.
- Modify the VI to control and measure a pulse train output from the counter line.
- Learn to use DAQ Assistant.
Sensors and Equipment
This experiment features the following sensors and equipment. Additional equipment may be required.
Ready to Experiment?
Ask an Expert
Get answers to your questions about how to teach this experiment with our support team.
- Call toll-free: 888-837-6437
- Chat with Us
- Email support@vernier.com
Purchase the Lab Book
This experiment is #8 of Hands-On Introduction to NI LabVIEW™ with Vernier. The experiment in the book includes student instructions as well as instructor information for set up, helpful hints, and sample graphs and data.
